Tel: 86-755-23725796     Mobile: +86-13480995660

Blog

Home > Blog > Content

The tips of placing stiffener use by most rigid flex circuit manufacturing process

MOKO Technology Ltd | Updated: Sep 08, 2016

Rich experience flex circuit manufacturing engineer overlaps a minimum of 0.762 Millimeters.
If you do not overlap stiffener and coverlay termination points, the resulting may stress points.
So all rigid flex circuit manufacturing process must care about the stiffener overlap.

The function of rigid flex circuit stiffener

During rigid flex circuit manufacturing process, place stiffener is the important factor.
But why we need a stiffener, or what is the function of rigid flexible PCB circuit stiffener.
PCB stiffeners can be used to reinforce the areas where components will be assembled.
Because during rigid flex circuit manufacturing assemble process require high reliability.
This means flexing circuit areas will don’t need a stiffener.

Both sides need rigid flex circuit board stiffeners

This is a special situation for rigid flex circuit manufacturing.
And not each rigid flex circuit board needs both side stiffeners.
If designers require assembly both sides rigid flex circuit stiffeners.
It will be required two laminations on the top and the bottom of the circuit.

MOKO Technology Ltd