Tel: 86-755-23725796     Mobile: +86-13480995660

Blog

Home > Blog > Content

What are the FPC trace design requirements?

MOKO Technology Ltd | Updated: May 22, 2018

In electronic devices, FPC is often used. It is a small circuit board but has a lot of components and circuit lines on it. Therefore, in order to achieve such a small range, the entire circuit can be ordered. In order to achieve a unified product, the FPC should be designed in advance and meet sufficient requirements before it can be achieved. Specifically, FPC's design requirements include the following aspects.


I. Preliminary design requirements for FPC alignment:

When carrying out the relevant design, it is necessary to have a good beginning with a distance of more than 0.5 mm in the bent place as the beginning of the trace. At the same time, the FPC manufacturers introduce the same vacant distance on both edges, the extra part. It should be cut out, and it would be best to add a pad for each side. At the same time, affordable FPC manufacturers are reminded to note that TCP and COF should adopt protective tapes to protect them, and COG needs black tape.


Second, FPC trace the middle process design requirements:

Don't arrange or design through holes in places where FPC products are bent. This can reduce stress and be good for bending. Also note that in the ACF range, especially its negative side must be kept flat and no unevenness should occur. FPC manufacturers also reminded that it is better to add a teardrop tray to the through hole when carrying out the routing. If you make a sinuous turn in a folded corner, it will produce better results.


Third, FPC alignment other details of the design requirements:

Since the FPC product itself is flexible, this time it is better to make good use of this point. Therefore, when the relevant design is carried out, in particular, the copper plating should be made into a wire mesh with corresponding specifications. This will also ensure that the entire board is flat. At the same time, FPC manufacturers stressed that the best distance between the copper skin and the circuit should be kept in order to protect the scalp from damage.


The above is the FPC trace design requirements include several aspects, in addition should also pay attention to the very need to do grounding treatment, so you can use the area and part of the FPC to use in these areas, you can make some holes around it In order to be able to better ground. At the same time, the popular FPC manufacturers should also pay attention to connect the other components, it should ensure that the positive and negative connections are correct, so as to avoid unnecessary trouble.


MOKO Technology Ltd